American Lighting LED Strip Light

Yes, you can cut LED strip lights. The benefit of LED strip lights is that they are made up of individual circuits allowing them to be cut. However, make sure to cut the strip lights along the cut lines to not destroy the strip lights. Cutting outside the dotted lines can lead to a damaged circuit, inconsistent lighting, and potential fire hazards.

Installing LED Strip Lights is a simple task that does not have to be time consuming. Below are the steps you can take to ensure a timely LED strip light installation.

• Decide where you want to place the LED strip lights in your home. Once you decide where they will go, measure the length of the area. Measure the length of the strip light using the measurement of the area.
• If you are using a longer LED strip light, you may need to cut the light. To cut it, find where the designated cut line is. Carefully cut along this line in a straight line.
• Now that the strip light is cut, clean the surface of any dirt or dust. This will allow the strip light to stay attached to the surface longer than if it was dirty.
• Once the area is clean, pull the sticky back off the light. Then, install the light by first pressing the plug-in end of the strip light on the surface. Continue to firmly press and place the light on the surface until the light is completely installed.
• When you complete the installation, test the light by plugging the light into the power outlet and see if it works.